Operating Tips - Toro 22295 Operator's Manual

1. Rear door
2. Bag-rod end (2)
3. Remove the rear-discharge plug by pushing in the latch
with your thumb and pulling the plug out from the
machine (Figure 17).
4. Install the bag-rod ends into the notches at the base of
the handle, and rock the bag back and forth to ensure
that the bag-rod ends are seated at the bottom of both
notches (Figure 18).
5. Lower the rear door until it rests on the grass bag.
Removing the Grass Bag
DANGER
The machine can throw grass clippings and other
objects through an opening in the mower housing.
Objects thrown with enough force could cause
serious personal injury or death to you or to
bystanders.
• Never remove the grass bag and then start the
engine without the discharge plug installed on
the machine.
• Never open the rear door on the machine when
the engine is running.
1. Stop the engine and wait for all moving parts to stop.
2. Raise the rear door.
3. Remove the bag rod on the grass bag from the notches
at the base of the handle (Figure 18).
4. Install the discharge plug; refer to Recycling the
Clippings (page 13).
5. Lower the rear door.
Figure 18
3. Notch (2)

Operating Tips

General Tips
•
Review the safety instructions and read this manual
carefully before operating the machine.
•
Clear the area of sticks, stones, wire, branches, and other
debris that the blade could hit and throw.
•
Keep everyone, especially children and pets, away from
the area of operation.
•
Avoid striking trees, walls, curbs, or other solid objects.
Never deliberately mow over any object.
•
If the machine strikes an object or starts to vibrate,
immediately stop the engine, disconnect the wire from
the spark plug, and examine the machine for damage.
•
Maintain a sharp blade throughout the cutting season.
Periodically file down nicks on the blade.
•
Replace the blade when necessary with an original Toro
replacement blade.
•
Mow only dry grass or leaves. Wet grass and leaves tend
to clump on the yard and can cause the machine to plug
or the engine to stall.
WARNING
Wet grass or leaves can cause serious injury if
you slip and contact the blade.
Mow only in dry conditions.
•
Clean under the mower housing after each mowing; refer
to Cleaning under the Mower Housing (page 20).
•
Keep the engine in good running condition.
•
Clean the air filter frequently. Mulching stirs up more
clippings and dust which clogs the air filter and reduces
engine performance.
•
Set the engine speed to the fastest position for the best
cutting results.
WARNING
Operating a machine with its engine running
at a speed greater than the factory setting can
cause the machine to throw a part of the blade
or engine your direction or in the direction of
bystanders, resulting in serious personal injury
or death.
– Do not change the engine speed setting.
– If you suspect the engine speed is faster
than normal, contact an Authorized Service
Dealer.
Cutting Grass
•
Grass grows at different rates at different times of the
year. In the summer heat, it is best to cut grass at the
64 mm (2-1/2 inch), 76 mm (3 inch), or 89 mm (3-1/2
14