Pioneer XS-R9 Service Manual page 66

XS-R9
QQ
3 7 63 1515 0
2. Operation Method When The Components Are Assembled
(1) How To Enter The Test Mode
Method 1 Short circuit the TEST pin after the power on.
Method 2 Short circuit the TEST pin or send the $A25F code by function CD during power on.
(Refer to the setup/release the test mode of section 6.1.2 Adjustment.)
Note : • When test mode is 2, set the remix to off and stop the CD.
• A companion is not only SX-R9, and it thinks in the case of the power supply jig as well in the test mode.
When TEST terminal is short-circuited under the condition that a bus is never received after the reset, ignores the information of bus
and judge it POWER ON state, and perform the independent movement.
(2) The Condition When Test Mode Was Entered
Function Make it a CD forcibly. (Only when it is connected with the power supply jig.)
Power Make it power on condition forcibly. (Only when it is connected with the power supply jig.)
Display Send it to the time information of the display data with "TEST2". Turn on and off the front LED.
(3) Release The Test Mode
How to release the TEST mode
Method 1 Release it with power OFF.
Method 2 Release it by short circuit the TEST pin.
TE
L 13942296513
(4) Movement and Key Reception in the Test Mode (it correspond with the remote control unit or bus
communication.)
CD Main Key
STOP key STOP
EJECT key EJECT
REPEAT key REPEAT
key
key
, key
Test check of the Remix Control Mixer (Connect to Stereo Tuner Amplifier and Remix Control Mixer in the CD TEST mode.)
Control Mixer
REMIX key REMIX LED light up/light out
SAMPLE MEMORY key SAMPLE segment of receiver light up/light out
SAMPLE MODE/PLAY key SAMPLE LED light up/light out
LOOP key LOOP LED light up/light out
CUE key CUE LED light up/light out
PLAY / PAUSE key PLAY LED light up/light out
MASTER TEMPO key MASTER TEMPO LED light up/light out
Receiver displays "TEMPO" ↔ time indication
TEMPO RESET key
TAP / AUTO CUE key AUTO CUE segment of receiver light up/light out
www
.
66
http://www.xiaoyu163.com
How to Enter the Test Mode
The movement of the CD after the TEST mode release
It becomes usual standby condition. (When it is connected with the receiver.)
It usually moves under the condition of function CD.
Key Command
STOP (Turn off all servos.)
Eject / Load
LD-on, Focus on
Spindle kick
Tracking off/on
, Slider outside/inside
Movement
x ao
y
i
http://www.xiaoyu163.com
8
Q Q
3 6 7 1 3
Movement
u163
.
2 9 9 4 2 8
Connection Condition
Connect with the power supply jig.
Connect with the receiver
1 5 0 5 8 2 9 9 4
m
co
9 9
2 8 9 9