13
WHEELS, TIRES
13.5
Checking the rear hub rubber dampers
Info
The engine power is transmitted from the rear sprocket to the rear wheel via 6 rubber dampers. They eventually wear out during
operation. If the rubber dampers are not changed in time, the rear sprocket carrier and the rear hub become damaged.
–
Push the rear wheel forward as far as possible and lay the chain on the rear sprocket.
–
Mount wheel spindle
yet.
–
Make sure that chain adjusters
–
Make sure that the markings on the left and right chain adjusters are in the same posi-
tion relative to reference marks
–
Tighten nut
Guideline
Nut, rear wheel spindle
–
Position the wheel speed sensor
Guideline
Screw, wheel speed sensor
–
Operate the foot brake lever repeatedly until the brake linings are in contact with the
brake disc and there is a pressure point.
M01388-10
Finishing work
–
Remove the rear of the motorcycle from the wheel stand. (
–
Check the chain tension. (
and chain adjuster
are fitted correctly on adjusting screws
. The rear wheel is then correctly aligned.
.
in the drill hole. Mount and tighten screw
p. 79)
. Mount nut
, but do not tighten it
M25x1.5
90 Nm
(66.4 lbf ft)
M6
6 Nm (4.4 lbf ft)
p. 71)
106
.
.