Toro XL Series Service Manual page 35

XL GEAR DRIVE
10. Reinstall the idler spring on bolt holding the idler
pulley to the idler assembly (Figure 64).
Figure 64
11. Adjust both the right and left engine belt guides so
they are within 1/8" (3mm) of the engine pulley
(Figure 65).
1/8" (3mm)
Figure 65
2 - 18
12. Install rear hitch plate and seat springs (Figure
66).
mvc-000a
13. Install battery and battery tray. Note: If battery
uses a battery drain tube, make sure the tube
is reinstalled through the rear hole in the
frame (Figure 67). Connect the battery cables.
mvc-000E
14. Reinstall the mower deck (refer to "Mower" section
on page 6 - 1).
15. Test operate the tractor to make sure the unit
shifts, brakes, and shifts on-the-go properly. Test
the safety interlock system.
Figure 66
Figure 67
XL Lawn Tractor Service Manual
mvc-0037
mvc-639