Installing The Wheels; Installing The Steering Wheel - Toro 12004TC Twister 1600 Operator's Manual

Step
1

Installing the Wheels

Parts needed for this step:
4 Wheel assembly
Procedure
1. Remove the fasteners securing the wheels.
2. Remove the shipping bracket secured to the
wheel studs.
3. Mount the wheels with the previously removed
fasteners (Figure 3) and torque to 45-65 ft-lb
(61-88 N⋅m).
Figure 3
1. Wheel assembly
2. Wheel nut
3. Wheel stud (rear wheel hub
shown)
Step
2
Installing the Steering
Wheel
Parts needed for this step:
1 Steering wheel
Procedure
1. Remove the nut and lock washer from the
steering shaft.
2. Slide the steering wheel and washer onto the
shaft. Position the steering wheel on the shaft
so that the cross beam is horizontal when the
tires are pointed straight ahead and the thicker
spoke of the steering wheel is downward.
3. Secure the steering wheel to the shaft with the
nut (Figure 4).
1. Steering wheel
2. Nut
11
Figure 4
3. Washer
4. Foam seal