Connecting The Drain Hose - Samsung WF8*F5E series User Manual

Connecting the hot water supply hose (selected models)
1. Connect the red L-shaped arm fitting (A)
supply hose to the hot water supply intake at the back of the
machine. Then tighten it by hand.
2. Connect the other end of the hot water supply hose to your sink's
hot water tap in the same way as you connected the cold water
supply hose.
To use only cold water, use the Y-piece.
Connecting the aqua hose (selected models)
The aqua hose was invented to ensure perfect leakage protection.
The aqua stop is attached to the aqua hose and automatically cuts the
water flow if the hose is damaged.
warning indicator (A)
It also displays a
Connect the aqua hose by assembling the aqua stop on the tap as
shown.

Connecting the drain hose

The end of the drain hose can be positioned in three ways:
Over the edge of a wash basin
The drain hose must be placed at a height between 60 cm and 90 cm.
To keep the drain hose spout bent, use the supplied
guide (A). Secure the guide to the wall with a hook or to the tap with a
piece of string to prevent the drain hose from moving.
(*): 60 ~ 90 cm
ln a sink drain pipe branch
The drain pipe branch must be above the sink siphon so that the end of the hose is at least 60cm above the
ground.
ln a standpipe
We recommend using a 65 cm high vertical pipe as a standpipe. It
must be no shorter than 60 cm and no longer than 90 cm. To keep the
drain hose spout bent, use the supplied
the drain hose to the standpipe with tie straps to prevent the drain hose
from moving.
The standpipe drain requires:
• A minimum diameter of 5 cm.
• A minimum carry-away capacity of 60 litres per minute.
(*): 60 ~ 90 cm
F400E_DC68-03633B-00_EN.indd 17
for the hot water
on the aqua stop.
plastic hose
plastic hose guide (A). Secure
English - 17
A
A
2015-08-13 11:52:40