Operation; Before You Begin; Location Of Controls; Starting The Pilot Flame - Travis Industries 564 SS Owner's Manual

6

Before You Begin

Read this entire manual before you use your new fireplace (especially the section "Safety
Precautions" on pages 4 & 5). Failure to follow the instructions may result in property damage, bodily
injury, or even death.

Location of Controls

Pilot Igniter
On/Off Switch
Gas Control Knob
Flame Adjust Knob
Comfort Control
Optional Blower Control
Optional Accent Light This knob controls the optional accent lights located behind
© Travis Industries

Operation

Optional Blower Control
Optional Accent Light
The pilot igniter is used only to start the pilot. When pressed, it sends an
electrical charge to the pilot assembly. This creates a blue spark directly next
to the pilot, igniting the pilot flame.
This control is used to turn the fireplace burners on and off.
This knob is used to control gas to the fireplace and for starting the pilot.
There are three positions, ON, OFF, & PILOT. The pointer to the left of the
knob indicates the position this knob is in.
This knob controls the flame height from low ("LO") to high ("HI"). The pointer
above the knob points to the position this knob is in.
This lever turns the rear burner on and off.
NOTE: THIS IS NOT A SHUTOFF VALVE.
This knob controls the speed of the optional internal convection blower
that pushes heated air into the room.
the logs.
Gas Control Valve
Comfort Control
Lift the control cover up and swing it
forward to access the controls.
4070626
The Pilot Flame can be
found under the rear log .
Pilot Igniter
ON/OFF Switch
Flame Adjust Knob
An instruction card for operating
the fireplace is attached to the
inside of the fireplace here.
Replace it for easy reference.
Gas Control Knob
100-01189_000