Stopping The Engine - Toro Z441 Z Master 74441 Operator's Manual

Figure 13
1. PTO—on
4. Move the choke control to the on position
before starting a cold engine (Figure 14).
Note: A warm or hot engine may not require
choking. After engine starts, move choke
control to Run position.
Figure 14
1. Choke—on
5. Move the throttle control to the Fast position
before starting a cold engine (Figure 15).
2. PTO—off
2. Choke—off
Figure 15
1. Throttle—fast
6. Turn the ignition key to Start. When the
engines starts, release the key (Figure 16).
Important: Do not engage starter for
more than 10 seconds at a time. If engine
fails to start allow 30 second cool-down
period between attempts. Failure to follow
these instructions can burn out starter
motor.
Figure 16
1. Off
2. Run
7. After the engine starts, move the choke to off
(Figure 14). If the engine stalls or hesitates,
move the choke back to on for a few seconds,
then move the throttle lever to desired setting.
Repeat this as required.

Stopping the Engine

1. Push the PTO to the off position (Figure 13).
2. Move the throttle lever midway between the
slow and fast positions (Figure 15).
3. Let the engine idle for 60 seconds.
4. Turn the ignition key to the off position and
remove the key (Figure 16).
5. Close the fuel shut off valve before transporting
or storing the machine.
18
2. Throttle—slow
3. Start