Think Safety First - Toro Z441 Z Master 74441 Operator's Manual

5. To raise the roll bar, remove the hairpin cotter
pins and remove the two pins (Figure 8).
6. Raise the roll bar to the upright position and
install the two pins and secure them with the
hairpin cotter pins (Figure 8).
Important: Always use the seat belt with
the roll bar in the raised position.
Figure 8
1. Roll bar
2. Raised position
Important: Tighten the front knobs
against the center roll bar ends (Figure 9).
Figure 9
1. Front handle
3. Pin
4. Hairpin cotter pin

Think Safety First

Please read all safety instructions and symbols
in the safety section. Knowing this information
could help you or bystanders avoid injury.
Operating on wet grass or steep slopes can
cause sliding and loss of control.
Wheels dropping over edges can cause
rollovers, which may result in serious injury,
death or drowning.
There is no rollover protection when the roll
bar is down.
Always keep the roll bar in the raised and
locked position and use the seat belt.
Read and follow the rollover protection
instructions and warnings.
To avoid loss of control and possibility of
rollover:
• Do not operate near drop-offs or near
water.
• Do not operate on slopes greater than
15 degrees.
• Reduce speed and use extreme caution
on slopes.
• Avoid sudden turns or rapid speed
changes.
16