Uniden XDECT 8355 Series Owner's Manual page 50

Registering Repeaters to the Base
If you are having trouble with a repeater or if you want to replace one, you
need to register the repeater to the base.
# Connect the repeater close to the base for easy access to the
necessary buttons and indicators. Locate the repeater in the
desired position after registration is complete.
1. On the base, open the menu and select Register Accy.
2. On the back of the repeater you want to register, press and hold the
registration button until the LINK light on the front starts to blink (about 2
seconds).
3. Release the button and wait for the Link light to turn on and steady (this
can take about 90 seconds). The repeater has been registered to the
base.
If
the Link light
won't turn on
the link light
continues
flashing
• Only register one repeater at a time. If more than one repeater is in
registration mode at the same time then they can interfere with each
other.
• Only register a repeater to one base at a time. If more than one base is
in registration mode at the same time then you can't control which base
the repeater registers to.
• If you want to register two repeaters to this base, just repeat these steps
with the second repeater.
50
Try
• checking the repeater's AC adaptor
• connecting the adapter to a different outlet.
• disconnecting the unit's AC adaptor. Wait about
ten seconds, then try again.
• making sure there are not already 6 repeaters
registered to this base.
• making sure no other base or repeater is in
registration mode.