Table of Contents
Advertisement
• Do not use paper designed for inkjet printers, as these may stick to the fusing unit and cause a
misfeed.
• If you load thin paper (64g/m
may appear. If this happens, turn the paper 90 degrees to load it in the grain direction.
• If you load paper of the same size in the same orientation in two or more trays, the machine
automatically shifts to the other tray - except the bypass tray - when the first tray in use runs out of
paper. This function is called "Auto Tray Switching". This saves interrupting a copy run to replenish
paper when making a large number of copies. See "System Settings", Connecting the Machine/
System Settings. For the setting procedure of the Auto Tray Switching function, see "Copier/
Document Server Features", Copy/ Document Server.
• If stackability is low when translucent paper (bond or vellum) is used, try loading the paper upside
down in the tray.
• If you wish to copy onto a transparent film entirely or copy solid fill onto it, contact your service
representative.
Paper Roll
• Use a paper roll that has a black core. You cannot use a paper roll with a non-black paper tube or
a paper roll where the trailing edge of the paper is glued to the paper tube. Do not use it, because
doing so will cause a paper jam when the paper runs out as well as cause other problems.
• If humidity is high, and the paper roll has expanded due to moisture, be sure to cut off with scissors
approximately 1000 mm (40 inches) before making copies or printing. Then load the paper roll,
and select [Cut] on the screen.
• Depending on the paper being used, a horizontal misregistration may occur. If this happens,
contact your service representative.
Translucent Paper
• Smooth out any curls in the paper before loading translucent paper (vellum).
• When using paper which was stored in high humidity and significantly wavy, cut its edge by 1 m or
more before copying it.
• When using translucent paper, load it in a grain direction.
• When using paper which has been stored in a humidity of 30% or below, cut approximately
1,000 mm of its end just before using it or use the humidifier.
• If you continuously copy in low temperature and the delivered sheets are bent at the corners, copy
each sheet with an interval of approximately 3 minutes.
• If you continuously copy 50 or more sheets of translucent paper of the length of A0 paper or more
with a solid-filled area that has the width of 2 mm or more and length of 900 mm or more, it may
2
or less) in a cross-grain direction, white spots and patchy images
Recommended Paper
121
Advertisement
Table of Contents
