Chapter 3 Setting Up The Pump(S); Introduction; Required Hardware; Mounting Screw Types - Omega Engineering OMEGAFLEX FPU500 User Manual

Setting Up the Pump(s)
3

3.1 Introduction

To attach a single pump directly to a pump motor, follow the
procedure in Section 3.3.1.
To stack two pumps to a motor, follow the procedure in
Section 3.3.2.
To attach the pump to an adapter plate (for your own motor),
follow the procedure in Section 3.3.3.
To use your own adapter plate, follow the procedure in
Section 3.3.4.

3.2 Required Hardware

Number of Pumps Mounting Screw
Stacked
1
2
* Optional adapter plate assembly includes mounting screws and pins
** Supplied standard with pump; can only be used to mount a single
pump
†
Must be specified at the time of ordering the pump; can only be used
for mounting 2 stacked pumps
Before you mount the pump to any pump motor, make
sure that power to the motor is turned off.
Mounting Screw
Type Part Number
Standard FPU500-SMS**
Long FPU500-LMS
NOTE
Number of
Mounting Screws
2
†
2
Adapter Plate*
Assembly Number
FPU500-AP
FPU500-AP
3-1