Greasing The Steering Head Bearing; Dismounting The Front Fender; Installing The Front Fender; Removing Headlight Mask With Headlight (Exc Eu) - KTM 450 EXC Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Greasing the steering head bearing

9.34

Dismounting the front fender

9.35

Installing the front fender

9.36

Removing headlight mask with headlight (EXC EU)

9.37
–
Tighten screw
Guideline
Screw, top steering stem
–
Check the cable harness, cable, brake and clutch line for free movement and free
laying.
–
Check the steering head bearing play. (
100022-11
x
(XC‑W USA)
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
(EXC EU)
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
800010-10
–
Remove screws
–
Make sure that the distance bushings remain in place.
500092-10
–
Ensure that the spacing sleeves are mounted in the fender.
–
Position the front fender. Mount and tighten screws
Guideline
Remaining screws, chassis
Info
Take care with the contact between the holding lugs and the start number
plate or headlight mask.
500092-10
–
Switch off all electrical equipment.
–
Remove screw
–
Loosen the rubber band
800018-10
.

M8
p. 39)
( p. 42)
x
( p. 43)
x
x ( p. 43)
x ( p. 44)
. Remove the front fender.

M6
and take off clamp.

. Push up the headlight mask and swing it forwards.

20 Nm
(14.8 lbf ft)
.

10 Nm (7.4 lbf ft)
45