Color / Bw - Samsung SCC-C4207P Owner's Instructions Manual

❙

COLOR / BW

COLOR/BW turns IR(Infrared) Filter on or off. In the poor
illumination environment, turns IR Filter off to raise the
sensitivity to the same level as an black-and-white camera while
in the good illumination environment, turns it on to convert to the
COLOR mode in the normal screen condition to lower the
sensitivity.
✔
COLOR
This is the IR Filter ON mode with a normal color screen.
You can press the [Enter] key to set the COLOR GAIN
LEVEL. And when the AGC function is on, you can set the
AGC COLOER LEVEL.
CAMERA ID OFF
IRIS ALC...
SHUTTER OFF
AGC LOW
WHITE BAL ATW1
FOCUS MODE ONEAF
MOTION DET OFF
COLOR/BW COLOR...
PRIVACY ...
SPECIAL ...
PRESET ...
EXIT QUIT
✔
BW...
This is the IR Filter OFF mode, black-and-white (with the
same sensitivity as a black-and-white camera). Select BW...
and press [Enter] and the BW submenu will appear. You
may determine to sent out BURST signals by ON or OFF
setting in this submenu.
❖ WHITE BAL will be marked --- so that setup is unavailable.
CAMERA ID OFF
IRIS ALC...
SHUTTER OFF
AGC LOW
WHITE BAL ---
FOCUS MODE ONEAF
MOTION DET OFF
COLOR/BW BW...
PRIVACY OFF
SPECIAL ...
PRESET ...
EXIT QUIT
25
(COLOR)
Press the
ENTER
GAIN (0)I--------
button.
AGC COLOR (0)----I----
RET
(BW)
Press the
ENTER
button.
BURST
RET
✔
AUTO...
Depending on illumination, it is automatically switched to
the COLOR or BW mode. In the poor illumination
environment, turns IR Filter off to convert to the Black-and-
White mode for better sensitivity and in the good
illumination environment, turns it on to convert to the
COLOR mode for worse sensitivity. Select AUTO and press
[Enter] and the AUTO BW submenu will appear to control
the BW level. Depending on ON or OFF, the BURST signal
may output or no. It also sets up the duration for conversion
and the brightness level for the conversion from the COLOR
mode to the BW mode. Duration options are 10Sec.,
30Sec., 1Min., and 5Min.. In the BW mode, the WHITE BAL
menu will be marked --- to make setup unavailable.
CAMERA ID
IRIS
SHUTTER
AGC
WHITE BAL
FOCUS MODE
MOTION DET
COLOR/BW
PRIVACY
SPECIAL
PRESET
EXIT
- ALARM ON : It sends out signals through the ALARM output
port in the BW mode.
- ALARM OFF : The ALARM output port is synchronized with the
MOTION DET finction regardiess of the COLOR/BW mode.
- BURST ON : The color burst signal is output together with
black and white composite video signal.
BURST OFF : The color burst signal is not output.
- LEVEL : You can set the brightness level that changes from
COLOR mode to BW mode in 3 steps : LOW, MEDIUM, and HIGH.
- DWELL TIME : Set the HOLDING time for switching
between COLOR and BW mode depending the changes in
the amount of light. You can set the HOLDING time to 10sec
(S), 30sec, 60sec, or 300sec( L).
❖ In AUTO mode, AGC will operates in high speed mode, and
you cannot change it manually, as it is indicated by "---".
OFF
OFF
(AUTO)
ALC...
OFF
---
ATW1
ONEAF
Press the
OFF
ENTER
AUTO...
BURST
OFF
button.
LEVEL
...
DURATION
...
RET
QUIT
E
ON
MEDIUM
S ---I--- L
26