Table of Contents
Advertisement
MAINTENANCE WORK ON CHASSIS AND ENGINE
x
Removing rear wheel
Position the spacing sleeves
Specification
Screw, front brake caliper
Operate the hand brake lever several times until the brake pads are lying correctly on
the brake disc.
Take the front from the work stand. (
Pull the front wheel brake and push down hard on the fork several times to align the
fork legs.
Fully tighten screw
Specification
Screw, fork stub
100168-10
Taking rear from work stand. (
Jack up the rear of the motorcycle. (
Remove nut
spindle
.
Push the rear wheel forwards as far as possible and take the chain off the rear sprocket.
100144-10
. Mount and tighten screws
M10x1.25
P. 62)
.
P. 63)
P. 63)
. Remove chain adjuster
. Holding the rear wheel, withdraw the wheel
.
®
45 Nm
Loctite
(33.2 lbf ft)
M8
15 Nm (11.1 lbf ft)
86
243™
Advertisement
Table of Contents
