Level 3 - Omega Engineering CN9400 User Manual

LEVEL 3

OUTPUT CONFIGURATION
Note: 'Read only' after initial configuration. rSET ALL full reset to
factory settings required to change
F
unction Options [Factory settings] shown in brackets
[nonE] rLY SSd
SP1.D
Select SP1 output device
[nonE] SSd rLY
SP2.D
Read SP2 output device
(read only)
Dual Relay and Dual SSd output options Models CN9411
and CN9422 are factory set. See page 22
Note: (when in initial configuration only)
Hold and or for 10 seconds to move to or from
output devices in shaded portion.
subsequently.
SP1.D
rLY1 rLY2 SSd1
rLY2 rLY1 SSd2
Sensor burn-out/break protection
BURN
Caution: Settings affect fail safe state.
[uP.SC]
dn.SC
1u.2d
1d.2u
Select output modes: Direct/Reverse
REU.D
Caution: Settings affect fail safe state.
[1r.2d]
1d.2d
1r.2r
1d.2r
Select Reverse on SP1 for heating and Direct for
cooling applications.
SP1 SP2
Upscale Upscale
Downscale Downscale
Upscale Downscale
Downscale Upscale
SP1 SP2
Reverse Direct
Direct Direct
Reverse Reverse
Direct Reverse
19