Related Manuals for Omega Engineering iLD Series
Summary of Contents for Omega Engineering iLD Series
- Page 1 MADE IN User’ s Guide ™ ® www.omega.com e-mail: info@omega.com iSeries info: www.omega.com/specs/iseries...
- Page 2 ® ®...
- Page 7 COMMUNICATIONS ETHERNET RESET RX TX ON COL DC POWER IN...
- Page 11 DEVICE #1 DEVICE #29 iLD Big Display TB4 1 2 3 DEVICE #31 -Tx/-Rx -Tx/-Rx +Tx/+Rx +Tx/+Rx Twisted shielded pair 120 Ohm Termination resistor DEVICE #2 DEVICE #30...
- Page 13 MODEL/SERIAL LABEL MODEL NO: SERIAL NO: INPUT POWER: MAC ADDRESS LABEL IN HEX CODE...
- Page 14 http://192.168.1.200 http://eis03ec...
- Page 18 C:\>ping eis03ec Pinging eis03ec with 32 bytes of data: Reply from eis03ec: bytes=32 time=15ms TTL=60 Reply from eis03ec: bytes=32 time=8ms TTL=60 Reply from eis03ec: bytes=32 time=8ms TTL=60 Reply from eis03ec: bytes=32 time=8ms TTL=60 Pinging statistics for eis03ec: Packets: Sent=4, Received=4, Lost=0 (0% loss) Approximate round trip times in milli-seconds: Minimum=8ms, Maximum=15ms, Average=9ms http://x.x.x.x...
- Page 21 Display Check Device Name Address Reading SP1 SP2 SP3 SP4 Display Units Format...
- Page 27 http://192.168.1.200...
- Page 29 TERMINAL SERVER reading...
- Page 30 Firmware Version 4.1 Admin Password:00000000 Admin. Login Successful Configuration Firmware Version 4.1 BD = 9600 (5) PT = odd (1) ST = 1 bit (0) DT = 7 bits (0) MD = RS-485 (1) TO = TT = SLAVE (1) TN = HN = eis1376...
- Page 31 Admin. Password:00000000 Admin. Login Successful iServer Configuration Command: cc description pppppp BD BaudRate 0-300,1-600,2-1200,3-2400,4-4800,5-9600,6-19200, 7-38400, 8-57600, 9-115200 PT Parity 0-none,1-Odd,2-even ST StopBits 0-1bits,1-2bits DT DataBits 0-7bits,1-8bits FC FlowControl 0-none,1-XON/XOFF,2-Hardware MD Mode 0-RS232, 1-RS485 MB Modbus/TCP 0-disable, 1-enable TO TimeOut xxxx ms Rang range 100-9999 TU TCP/UDP 0-TCP, 1-UDP TT TerminalType...
- Page 33 C:\>arp - 192.168.1.96 No ARP Entries Found C:\>ping 192.168.1.96 Pinging 192.168.1.96 with 32 bytes of data: Reply from 192.168.1.96=bytes=32 time=5ms TTL=32 Reply from 192.168.1.96=bytes=32 time=3ms TTL=32 Reply from 192.168.1.96=bytes=32 time=3ms TTL=32 Reply from 192.168.1.96=bytes=32 time=4ms TTL=32 C:\>arp -a 192.168.1.96 Interface: 192.168.1.118 Internet Address Physical Addresss 192.168.1.96...
- Page 47 Note: *Units configured for external low power dc voltage, 12-36Vdc Note: **I/O signal and control lines require shielded cables and these cables must be located on conductive cable trays or in conduits. Furthermore, the length of these cables should not exceed 30 meters...
- Page 48 ® omega.com...