Miele CVA 4060 Operating And Installation Instructions page 82

Installation
Downloaded from CoffeeMachineManual.com Manuals
82
^ Push the machine all the way into the niche until there is a
resistance. Then check the height to make sure it is sitting
centrally in the unit and that it is level.
If this is not the case, realign the 4 feet underneath the
machine using the large allen key.
The feet can be unscrewed by up to approx. 10 mm.
^ If the furniture unit walls are 19 mm thick you will need to
drill four holes in the sides for securing the machine. To
mark the position of these holes:
– Align the machine in the niche. Screw the side socket
screws inside the machine in a little so that they make
indents in the side walls and then unscrew them again.
– Take the machine out of the niche and drill ø 4.5 mm holes,
2 mm deep where you made the indentations.
^ Connect the machine to the electricity supply.
^ Push it all the way into the niche until you feel resistance.
^ Open the machine door and partially tighten the side
socket screws.
^ Carefully turn the lower socket screws a to centre the
machine in the niche.