Setup For Rate Monitor; Setup For Rpm Monitor - Omega Engineering DP3300 Series User Manual

DP3300 Series User's Manual
FUNCTION
Latching or non -
latching relay setup.
Limit outputs prog-
rammed as normally
open or closed

SETUP FOR RATE MONITOR:

If channel 2 is programmed to operate in RATE mode, then the following steps are performed during SETUP procedure:
FUNCTION
Time base for RATE
calculation (In seconds)
Decimal point
placement
Scaler
Division Factor
Limit 1
Limit 2
Limit 3
Relay deadband
Limit outputs prog-
rammed as normally
open or closed

SETUP FOR RPM MONITOR:

DISPLAY SHOWS
'LATCH' for latching mode.
'NON LCH' for non latching mode.
LT1 N.O. or LT1 N.C
LT2 N.O. or LT2 N.C
LT3 N.O. or LT2 N.C
DISPLAY SHOWS
'rAtE tb' followed by previously
programmed value e.g. '1.999'
dP 9999
dP 999.9
dP 99.99
dP 9.999
'SCALER' followed by preset scaler
value e.g. 10.00024 with active digit
flashing.
'DIV FAC' followed by preset division
by preset division factor. (e.g. 12`
with active digitflashing).
'CH1 LT1' followed by preset Limit 1
value e.g. 123.4 with active digit
flashing.
For limits 2 &3 CH1 LT2, CH1 LT3
followed by limit value.
'dEAdbd' followed by deadband
value e.g. 0002
LT1 N.O. or LT1 N.C
LT2 N.O. or LT2 N.C
LT3 N.O. or LT2 N.C
Page20
TO CHANGE
Push ^v key to obtain alternate mode.
Use ^V key to obtain
alternate mode.
TO CHANGE
Push ^v key to increment or decrement active
digit. Push <NXT> key to make next digit active
Push ^v key to
move decimal
point to desired
position.
Push ^v key to increment or decrement
active digit. Push <NXT> key to change
active digit.
Push ^v key to increment or decrement
active digit. Push <NXT> key to
change active digit.
Push ^v key to increment or decrement
active digit. Push <NXT> key to
active digit.
NOTE: Limit3 is audio visual alarm only
--- it has no relay output.
Push ^v key to increment or decrement
active digit. Push <NXT> key to make
next digit active.
Use ^V key to obtain
alternate mode.