Table of Contents
Advertisement
2.2.4 Setting the Unit
(See Section 4.3 of the instruction manual for the VR200.)
Format: SNp1, p2
Example: SN02, kg
2.2.5 Setting the Waveform Span Rate (TIME/DIV)
(See Section 4.4 of the instruction manual for the VR200.)
Format: SWp1
Example: SW1
2.2.6 Setting the Clock
(See Section 4.5 of the instruction manual for the VR200.)
Format: SDp1, p2
Example: SD96/03/13, 15:02:00
2.2.7 Copying the Channel Settings
(See Section 4.6 of the instruction manual for the VR200.)
Format: SYp1, p2
Example: SY01, 03
Note
You can only copy from a lower channel number to a higher channel number.
p1:
Channel number (CC)
p2:
Engineering unit (up to six characters)
This example assigns the unit "kg" to channel 2. Note that a unit can only be
assigned to channels of the SCL or SQRT input.
p1:
Select the waveform span rate from 1, 5, 10, 20, 30, and 60
(minutes).
This example sets the waveform span rate to 1 minute.
p1:
Date (YY/MM/DD)
YY: The last two digits of the Western year
MM: 01 to 12
DD: 01 to 31
p2:
Time (HH:MM:SS)
HH: 00 to 23
MM: 00 to 59
SS: 00 to 59
p1:
Channel number (CC) from which you want to copy the settings
(origin)
p2:
Channel number (CC) to which you want to copy the settings
(destination)
This example copies all settings from channel 1 to channel 3.
2.2 Program Set Commands
2 - 5
Advertisement
Table of Contents
