Table of Contents
Advertisement
Offset:
Next configurable function is offset and is indicated by the message 'OFFSET' followed by current offset
value. To change the value of flashing digit press ^v key. To move the flashing digit, push <NXT> key.
After programming the desired value of offset, push the "SETUP" key to get to the next function.
Tare:
Tare mode is indicated by the word 'TARE' followed by current Tare value. To change the value of
flashing digit, press ^v key. To move the flashing digit, push <NXT> key. After programming the desired
value of 'TARE' push 'SETUP' key (Minimum programmable tare is zero, maximum is equal to the scale
value). This will take us back to the very beginning of SETUP mode with the display showing the message
'SCALING'.
PROGRAM LIMITS:
Process Limits (1 thru 4):
If selection made from programming groups is for 'PROG LT' then the very first parameter programmed is
process limit 1. This is indicated by the message 'PrG LT1' followed by pre-programmed value of the
limit. Again, use <NXT> key to move flashing to the next digit and ^v key to increment/decrement the
value of the flashing digit.
The following steps are very similar to the above (i.e. for Limits 2,3 and 4 and also if Limits 3 and 4 are
setup as process limits) and allow you to enter process limits 2 through 4. However, limits 3 and 4 can be
configured to work as rate and deviation limits, respectively. Therefore, after programming limit 2, the next
step takes us into selection of limit 3 as rate or process limit.
Selection of Limit 3 as Process or Rate Limit:
This step comes after programming Limit 2 and is indicated by the message 'LT3 RTE' (if Limit 3 is setup
as Rate limit) or 'LT3 Pr' (if Limit 3 is setup as Process limit). Alternate selection can be made by pushing
^v key. Push SETUP key after making the selection.
Programming Limit 3:
As Process Limit:
If Limit 3, in the above step, was configured as a Process limit, then the message displayed on entering this
mode will be 'PrG Lt3'. This will be followed by displaying of current value of Limit 3 . Use <NXT> key
to move flashing to the next digit and ^v key to increment/decrement the value of the flashing digit.
As Rate Limit:
If Limit 3, in the above step, was configured as a Rate limit, then the message displayed on entering this
mode will be 'RATE Lt'. This will be followed by displaying of current value of Limit 3 . Use <NXT>
key to move flashing to the next digit and ^v key to increment/decrement the value of the flashing digit.
6
Advertisement
Table of Contents
