Powering Off The Projector; Warning Indicator - Optoma HD8600 User Manual

N
N
ote ote
Contact the nearest
service center if the
projector displays these
symptoms. See page
57 for more information.
Downloaded From projector-manual.com Optoma Manuals

Powering Off the Projector

button on the remote control or
1. Press the " "
on the rear side
interval in between
button will display the following message on the screen.
Press the button again to confirm the shut down. If the
button is not pressed, the message will disappear in 5
seconds.
2. The cooling fans continue to operate for about 60 seconds
for cooling cycle and the Power LED
When the light is solid red, the projector has entered standby
mode.
If you wish to turn the projector back on, you must wait until
the projector has completed the cooling cycle and has
entered standby mode. Once in standby mode, simply press
" " button on the rear of the projector or
remote control to restart the projector.
3. Disconnect the power cord from the electrical outlet and the
projector.
4. Do not turn on the projector immediately following a power
off procedure.

Warning Indicator

▀■
When the "LAMP" indicator led
projector will automatically shut down. Please call the
nearest Optoma facility for assistance.
▀■
When the "TEMP" indicator
projector has overheated. The projector will shut down
automatically.
Under normal conditions, the projector can be switched on
again after it has cooled down.
▀■
When the "TEMP" indicator
fan has failed.
Installation
of the projector two times with one second
to turn off the projector. First push of
" "
" " turns red, it indicates the
flashes red, it indicates the
" "
" " button
will turn blue.
" "
" " on the
is lit orange, the