Installation
N
N
ote
ote
Turn on the projector
first and then select the
signal sources.
Downloaded From projector-manual.com Optoma Manuals
Powering On/Off the Projector
Powering On the Projector
1. Remove the lens cap.
2. Securely connect the power cord and signal cable. When
connected, the power led will turn red.
3. Turn on the lamp by pressing
the projector or
The power led
The startup screen will display in approximately 30 seconds.
The first time you use the projector, you can select your
preferred language from quick menu after the startup screen
display.
4. Turn on your source that you want to display on the screen
(computer, notebook, video player, etc). The projector will
detect the source automatically and will display on the
screen. If not, push menu button and go to "SETUP". Make
sure that the "Source Lock" has been set to "Off".
▀■
If you connected multiple sources at the same time, press
the "Source" key on the remote control to switch between
inputs.
1
"
on the remote control.
"
"
will now flash blue.
" "
2
"
button on the rear of