Optoma HD8600 User Manual page 42

User Controls
N N
ote ote
"IRE" is only supported
on NTSC signal.
Downloaded From projector-manual.com Optoma Manuals

Frequency: Change the display data frequency to match the

frequency of your computer's graphic card. When you
experience a vertical flickering bar, use this function to make an
adjustment.
Phase: Synchronize the signal timing of the display with the

graphics card. If you experience an unstable or flickering
image, use this function to correct it.
H Position: Adjust the horizontal position.

V Position: Adjust the vertical position.

White Level : Allow user to adjust White Level when inputting

SVideo or Video/CVBS signals.
Black Level : Allow user to adjust Black Level when inputting

SVideo or Video/CVBS signals.
Saturation : Adjust a video image from black and white to fully

saturated color. Press the
the image. Press the
image.
Hue : Adjust the color balance of red and green. Press the

to increase the amount of green in the image. Press the
increase the amount of red in the image.
IRE : Adjust measurement of composite video signals.

Black Level (for HDMI): Allows user to adjust the Black Level

for HDMI signals.
Reset
Return the adjustments and settings to factory default values.
Current : Return the current menu's settings to factory default.

All : Return the settings for all menus to factory default values.

to decrease the amount of color in
to increase the amount of color in the
to