Troubleshooting - Fellowes POWERSHRED DS-500C Instruction Manual

BASIC SHREDDING OPERATION
Continuous operation:
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond

TROUBLESHOOTING

PAPER JAM
1 2
Alternate slowly back and forth
Set to Reverse (R)
for 2-3 seconds
RODUCT MAINTENANCE
OILING SHREDDER
All cross-cut shredders require oil for peak
performance. If not oiled, a machine may
experience diminished sheet capacity, intrusive
noise when shredding and could ultimately
stop running. To avoid these problems, we
recommend you oil your shredder each time
you empty your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
LIMITED PRODUCT WARRANTY
PAPER/CARD
1 2
Plug in and put
Set to Auto-On (I)
disconnect power
switch in ON (I) position
3 4
Set to Off (O)
and unplug
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
2
Set to Off (O)
3
Feed paper/card
straight into paper
entry and release
5 6
Gently pull uncut Set to Auto-On
entry. Plug in.
shredding
3
Set to Reverse (R)
* Apply oil
2-3 seconds
across entry
incurred by Fellowes to provide parts or services outside of the country where the shredder is initially
4
When finished shredding
set to OFF (O)
Shredder doesn't start:
Make sure bin is pushed in
Make sure safety lock is in unlock
position
3