Procedure - HP StorageWorks NAS 1500s Installation Manual

Procedure

To initialize the NAS 1500s:
1. Connect the Ethernet cables to the respective network ports
of the NAS 1500s and the corresponding network segments.
See
ports on the NAS 1500s.
2. Go to the NAS device and power it on. It will be several
minutes before the NAS device is accessible on the network.
Note:
has started.
3. Open Internet Explorer on the PC. Enter
serial number of the NAS 1500s followed by a hyphen (-),
and then
Example:
Note:
name was previously set.
4. Login to the WebUI. This launches the WebUI configuration
application (Rapid Startup) on the target HP StorageWorks
NAS device, as shown in
Note:
password is hpinvent. The WebUI uses the same login as the local
administrator's account or an account with administrative privileges.
5. Go to
complete the setup procedures.
32
Figure 2 and
The NAS device will respond when the NAS operating system
. Press Enter.
:3202
https://D4059ABC3433-:3202
Substitute the server name for the serial number if a server
The default login for the WebUI is administrator and the
"Rapid Startup Wizard
Table 2 for the locations of the network
Figure
configuration" on page 34 to
https://
8.
NAS 1500s Installation Guide
, the