Panasonic MK-F800 Operating Instructions Manual page 13

FOOD PROCESSOR
Operating with Auto Menu
1
1
2
After completing the assembly steps, plug-in the plug
into the socket and turn on the Power Switch. The
Mode Indication L.E.D.s will light up and blink.
3
Each Auto Menu has a pre-programmed driving time.
*Each lighted bar represents 10 seconds of driving time.
Push the ON/OFF Switch to start the operation.
5
After the processing is completed, switch off the Power
Switch and unplug from the socket.
Note:
• Always ensure that the Knife Blade is inserted before adding ingredients into the Bowl.
• The Driving Time of the Auto Menu can be increased or decreased by adjusting the Rotary Dial if necessary.
• The operation of the Auto Menu can be stopped prematurely by pushing the ON/OFF Switch before the set
duration ends.
• *For Paste Auto Menu, each lighted bar represents 1 minute. The lighted bar will decrease at every 1 minute
interval.
• Depending on the speed and amount of ingredients used, there will be significant vibrations present. In that
case, hold down the Bowl Lid with both hands to support it during its operation.
-KNIFE BLADE-
2
Select the required Auto Menu mode (except the Drainer
Mode). The selected Mode Indication L.E.D. will light up
and a beep sound will be heard. The Driving Time and
ON/OFF Switch Indication L.E.D. will light up and blink.
4
During operation, the Driving Time L.E.D. will turn off
one by one after every 10 second intervals until the set
duration is completed and 4 beep sounds will be heard.
The Mode Indication L.E.D.s will light up and blink.
6
2
1
Remove the Knife Blade from the Bowl before removing
the processed ingredients.
13