Transducer; Transducer Mounting; Power Boats; Sailboats - Standard Horizon FF525 Installation Manual

3. TRANSDUCER

WHEN PLUGGING IN OR UNPLUGGING A TRANSDUCER TO THE FF525 MAKE SURE
POWER IS TURNED OFF.
The transducer is a device that transmits and receives sound waves into the water. The
active component inside the transducer is commonly referred to as an element but actually
is a piezoelectric ceramic material.
3.0

TRANSDUCER MOUNTING

3.0.0

Power Boats

Basically there are two hull types of powerboats: Planing and Displacement. In the following
pictures the boxes with lines are where the transducer should be installed.
The planing hull allows the boat to rise quickly out of the water, allowing the boat to travel
at higher speeds.
The displacement hull does not ride up on top of the water; rather it pushes through the water.
3.0.1

Sailboats

Mount the transducer in the first front 1/3 part of the boat, just forward of or the side of the
keel.
Page 12
WARNING
Figure 3.0.0 - Planing (on the left) and Displacement (on the right)
Figure 3.0.1 - Fin Keel (on the left) and Full Keel (on the right)
Figure 3.0.1a - Mounting Area
FF525 Installation Manual