Honda VFR800 Owner's Manual page 128

Rear Wheel Removal
1. Place the motorcycle on its center stand.
2. Remove the four rear wheel nuts ( ).
3. Remove the rear wheel ( ) slowly.
(2)
(1) Rear wheel nuts
(2) Rear wheel
www.ClassicCycles.org
1
2
(1)
Installation Notes:
To install the rear wheel, reverse the
removal procedure.
Tighten the rear wheel nuts to the specified
torque:
108 N·m (11.0 kgf·m , 80 lbf·ft)
After installing the wheel, apply the brake
several times and then check if the wheel
rotates freely. Recheck the wheel if the
brake drags or if the wheel does not rotate
freely.
If a torque wrench was not used for
installation, see your Honda dealer as soon
as possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
121