RM-180
RF Troubleshooting and Tuning Guide
6.
Click Start.
7.
Connect the signal generator to the phone and set frequency and amplitude as instructed in the
step 1 of 3 - Rx Calibration with band EGSM900 pop-up window.
Note:
The calibration uses a non-modulated CW signal. Increase the signal generator level by cable
attenuation and module jig probe attenuation!
8.
To perform the tuning, click OK.
Issue 1
COMPANY CONFIDENTIAL
Copyright © 2006 Nokia. All rights reserved.
Nokia Customer Care
Tuning
Page 7 –21