Wcdma Rssi Measurement - Nokia RM-132 Service Manual & Parts Manual

RM-132; RM-133
RF Troubleshooting and Manual Tuning Guide
• Set AGC Mode to Algorithm.
• Set Channel to 10700.
• Set AFC Algorithm to OFF (Default = OFF).
Next actions
When settings are ready, click Start to activate them.
If settings are changed later on (for example, you give a new channel number), you will need to click Stop
and Start again.
Note: Clicking Stop also disables Tx Control if that was active!

WCDMA RSSI measurement

Prerequisites
WCDMA Rx must be activated before RSSI can be measured. See
measurement (page 7–12).
Steps
Phoenix service software.
1. Start
2. Choose Testing→WCDMA→Rx Power Measurement .
Rx Power Measurement window, choose the following settings:
3. In the
• Mode: RSSI
• Continuous Mode
Issue 1
Rx Control window
Figure 53
COMPANY CONFIDENTIAL
Copyright © 2006 Nokia. All rights reserved.
WCDMA Rx chain activation for manual
Nokia Customer Care
Page 7 –13