Clarion nax980hd Owner's Manual page 69

Wire Connection
Notes
on
wire connection
When connecting the plugs and sleeves, be sure to insert the plug until it locks securely. After
completing connections, fasten the cords using cord clamps and tapes.
Cut5 mm.
Female~-H. ~Male
~o.t:_=~~lO"'~=
Sleeve
---.I
®Ol===
/
If the male knob is in the shape shown at
@,
cut the female sleeve about 5 mm.
Example of connecting reverse gear or handbrake signal cord
Connect each signal cord using the supplied electro-taps.
From this unit
Tighten with the vehicle side screw and fasten
securely to the vehicle metal part.
3 Electro-tap
1. Place the cord from this unit at the stopper, and fold it back in the direction of the arrow.
2. Pass the vehicle signal cord through, and fold it back in the direction of the arrow.
Vehicle and main unit signal cord
Stopper Power supply cord from this unit
l
Vehicle and main unit signal cord
~
~po~er
supply cord from this unit
Example of relay usage
Use a special installation kit (relay cord kit), sold separately, prepared specifically for your model. For
applicable models, consult the dealer where you purchased this unit.
Note:
When connecting the main power supply cord (yellow) of the main unit, connect it to a spare terminal of this unit.
(Yellow) (Yellow)
~
....
ETD;~8m=a=i=n=u=ni=t
= ===:;;
Relay cord (Sold separately)
Conforms to EIAJ standard (CP2501)
Ground cord from this unit
I """"'""-------------------.,
I
N!f'
10
NAX980HD
Wire Connection
Notes
on
wire connection
When connecting the plugs and sleeves, be sure to insert the plug until it locks securely. After
completing connections, fasten the cords using cord clamps and tapes.
Cut5 mm.
Female~-H. ~Male
~o.t:_=~~lO"'~=
Sleeve
---.I
®Ol===
/
If the male knob is in the shape shown at
@,
cut the female sleeve about 5 mm.
Example of connecting reverse gear or handbrake signal cord
Connect each signal cord using the supplied electro-taps.
From this unit
Tighten with the vehicle side screw and fasten
securely to the vehicle metal part.
3 Electro-tap
1. Place the cord from this unit at the stopper, and fold it back in the direction of the arrow.
2. Pass the vehicle signal cord through, and fold it back in the direction of the arrow.
Vehicle and main unit signal cord
Stopper Power supply cord from this unit
l
Vehicle and main unit signal cord
~
~po~er
supply cord from this unit
Example of relay usage
Use a special installation kit (relay cord kit), sold separately, prepared specifically for your model. For
applicable models, consult the dealer where you purchased this unit.
Note:
When connecting the main power supply cord (yellow) of the main unit, connect it to a spare terminal of this unit.
(Yellow) (Yellow)
~
....
ETD;~8m=a=i=n=u=ni=t
= ===:;;
Relay cord (Sold separately)
Conforms to EIAJ standard (CP2501)
Ground cord from this unit
I """"'""-------------------.,
I
N!f'
10
NAX980HD