Broiler Pan And Rack; Oven Light Replacement; Heating Elements - GE JKP44 Use And Care Manual

Proper care and cleaning are important so your oven will give you efficient
oven to assure safe and proper maintenance.
BE SURE ELECTRICAL POWER IS OFF BEFORE CLEANING
ANY PART OF THE OVEN.

Broiler Pan and Rack

After broiling, remove the broiler pan from the oven.
Remove the rack from the pan. Carefully pour out
the grease from the pan into a proper container. Wash,
with a soap-filled or plastic scouring pad. Rinse the
broiler pan and rack in hot water.
If food has burned on, sprinkle the rack with
detergent while hot and cover with wet paper towels
or u dish cloth. Soaking the pan will remove burned-
on foods.
The broiler pan may be cleaned with a commercial
oven cleaner. Do not use an oven cleaner on the rack.

Oven Light Replacement

CAUTION: Before replacing your oven light bulb,
disconnect the electrical power for your oven at
the main fuse or circuit breaker panel. Be sure to
let the light cover and bulb cool completely before
removing or replacing them. When in use, light bulbs
moist cloth or towel. When cleaning, avoid touching
warm lights with cleaning cloths if the light cover
is removed.
The oven light (bulb) is covered with a removable
glass cover which is held in place with a wire.
Remove the oven door, if desired, to reach the
cover easily.
remove:
To
Hold your hand under the cover so it doesn't fall
when released. With fingers of the same hand, firmly
push back the wire cover holder. Lift off the cover.

Heating Elements

Oven
Do not clean the bake element or the broil element.
soil will burn off when the elements are heated.
Any
The bake element can be lifted gently to clean the
oven floor. If. spillovers, residue or ash accumulate
element gently wipe around the
around the bake
element with warm water.
-
-
Do not clean the broiler pan or rack in self-
cleaning oven.
Both the broiler pan and rack can also be cleaned in
the dishwasher.
Do not store a soiled broiler pan and rack anywhere
in the oven.
DO NOT REMOVE ANY SCREWS.
Replace bulb with 40-watt home appliance bulb.
To replace the cover:
Place it into the groove of the light receptacle.
Pull the wire forward to the center of cover until it
snaps in place. When in place, the wire holds the
cover firmly. Be certain the wire is in the depression
in the center of the cover.
Connect electrical power to the oven.
Wire cover holder
Broil Element
Bake Element
27