Around The Toner Cartridge; Paper Feeding - Samsung ML-1640 Series User Manual

Around the toner cartridge

1. Open the front cover.
For ML-2240 Series, if you have installed the dust cover, remove the
dust cover before opening the front cover.
2. Pull the toner cartridge out and remove it from the machine.
• Do not touch the green surface (or sky blue), the OPC drum,
with your hands or any other material. Use the handle on the
cartidge to avoid touching this area.
• Be careful not to expose the green surface (or sky blue), the
OPC drum, into light.This will cause damage to the OPC
drum.Cover the toner cartridge's OPC drum with paper to
avoid damaging it from the light.
• Do not turn the toner cartridge over.
Downloaded From ManualsPrinter.com Manuals
3. Gently pull the paper toward you.
4. Check that there is no other paper in the machine.
5. Reinstall the toner cartridge and close the front cover. Your machine
resumes printing the document from failed pages.
SOLVING OTHER PROBLEMS
The following chart lists some conditions that may occur and the
recommended solutions. Follow the suggested solutions until the problem is
corrected. If the problem persists, call for service.

Paper feeding

CONDITION
Clear the paper jam. See page 30.
Paper is jammed
during printing.
• Ensure there is not too much paper in the tray.
Paper sticks
The tray can hold up to 150 sheets of paper,
together.
depending on the thickness of your paper.
• Make sure that you are using the correct type
of paper. See page 23.
• Remove paper from the tray and flex or fan the
paper.
• Humid conditions may cause some paper to
stick together.
• Different types of paper may be stacked in the
Multiple sheets of
tray. Load paper of only one type, size, and
paper do not feed.
weight.
• If multiple sheets have caused a paper jam,
clear the paper jam. See page 30.
• Remove any obstructions from inside the
Paper does not feed
machine.
into the machine.
• Paper has not been loaded correctly. Remove
paper from the tray and reload it correctly.
• There is too much paper in the tray. Remove
excess paper from the tray.
• The paper is too thick. Use only paper that
meets the specifications required by the
machine. See page 18.
SUGGESTED SOLUTIONS
Troubleshooting_ 32