Olympus D-555 ZOOM Advanced Manual page 101

Possible cause
The subject was out of
the working range of the
flash.
The subject was too
small and was backlit.
The sequential shooting
mode was used.
The center of the subject
is too bright.
Bright subjects such as
snow will turn out darker
than their natural colors
in the image.
The colors of pictures look unnatural.
Indoor lighting affected
the picture's colors.
No white in the picture.
The white balance
setting is wrong.
Part of the picture is dark.
The lens was partly
blocked by your finger or
the strap.
Pictures you have taken do not appear on the monitor.
The power is off.
The camera is in the
shooting mode.
There are no pictures in
the card.
There is a problem with
the card.
Single-frame erase and all-frame erase cannot be performed.
The pictures are
protected.
Corrective action
Shoot within the flash working range.
Set the flash to [ # ].
Higher shutter speeds are used during
sequential shooting, which may result in
pictures that are darker than usual. Set
[DRIVE] to [o].
If the center of the subject is too bright, the
image as a whole emerges darker. Adjust the
exposure compensation toward plus (+).
Adjust the exposure compensation toward
plus (+).
Set the white balance according to the
lighting.
Include something white in the picture, or
shoot using [#].
Adjust the white balance according to the
light source.
Hold the camera correctly, keeping your
fingers and the strap away from the lens.
Slide the POWER switch to q to turn the
camera on in playback mode.
Press the QUICK VIEW button or slide the
POWER switch to q to switch to the
playback mode.
[NO PICTURE] is displayed on the monitor.
Record pictures.
See "Error codes".
Cancel the protection of the pictures.
Troubleshooting
Ref.
page
P. 34
P. 34
P. 41
P. 37
P. 37
P. 38
P. 34
P. 38
P. 19
P. 9
P. 9
–
P. 96
P. 54
101
9