Troubleshooting - Olympus CAMEDIA D-360L Instructions Manual

TROUBLESHOOTING

OPERATING PROBLEMS
The camera does not work.
1
The power is OFF.
[ Open the lens barrier to turn on the power. (P. 31)
2
The batteries are loaded incorrectly.
[ Reload the batteries correctly. (P. 25)
3
The batteries are exhausted.
[
Replace the batteries with new ones. (P. 25)
4
The batteries are temporarily unable to function.
[
Keep the batteries warm while using the camera.
5
The camera is set to the stand-by mode.
[
Close and open the lens barrier. (P. 31)
6
The camera is connected to a personal computer.
[
The camera does not work when connected to a computer. (P. 99)
No picture is taken when the Shutter release button is pressed.
1
The flash has not finished charging or the previous picture is being
written into the card.
[
Remove your finger from the Shutter release button and wait until
the Green lamp stops blinking. (P. 40/49)
2
There is no card in the camera or there is a problem with the card.
[
See the Error code chart. (P. 117)
3
The card is full.
[
Replace the card, delete unwanted pictures or transfer the data to
a computer and delete all of the pictures. (P. 28/76/82/97)
4
The batteries ran out.
[
Replace the batteries with new ones. (P. 25)
5
The battery power is low.
[
Replace the batteries with new ones. (Do not open the Battery
compartment cover when the Card access lamp is blinking.) (P. 25)
6
A write-protect adhesive seal is placed on the card or there is no card
in the camera.
[
Insert a new card in the camera. (P. 28)
7
The camera is in the Display mode.
[
Open the lens barrier. (P. 31)
112