Electric Handle Heating; Starting / Stopping The Engine - Stihl MS 661 C-M Instruction Manual

Electric Handle Heating

Switching on the handle heating system
(depending on equipment version)
Set switch to F – to switch off, return
N
switch to the 0 position
Overheating during continuous use is
impossible. The heating system is
maintenance-free.
MS 661 C-M
Starting / Stopping the
Engine
Positions of the Master Control lever
STOP engine position or † – when the
Master Control lever is pushed towards
STOP or †, the ignition system is
interrupted and the engine turns off.
When the Master Control lever is
released, it will return to the operating
position F.
WARNING
Once the engine comes to a standstill
and the Master Control Lever returns to
the operating position the ignition is
automatically switched on again and the
engine is capable of being restarted.
Operating position F – engine is running
or capable of being restarted
Start position } – optimal position for
starting the engine
Adjusting the Master Control lever
To adjust the Master Control lever from
operating position F to start position },
press and hold down the throttle trigger
lockout and throttle trigger
simultaneously – set Master Control
lever to start position } and
simultaneously release the throttle
trigger and throttle trigger lockout.
Simultaneously pressing the throttle
trigger lockout and blipping the throttle
trigger causes the Master Control lever
to jump from the position } to
operating position F.
To switch off the engine, push the
Master Control lever to STOP or †–
when the Master Control lever is
released, it returns to the
operating position F.
Holding the chain saw
There are two ways to hold the chain
saw during starting.
English
35