5. Click the Lights sheet.
6. From Target partition, select Display.
7. From State partition, select On.
8. Set Level to 100 and click Write.
9. Click Close to end the lights testing.
Note:
It is possible to set any value between 0...100 for display lights.
Switching display lighting OFF using Phoenix
Prerequisites
First, go through steps 1-5 in
Steps
1. From Target partition, select Display.
2. From State partition, select Off.
3. Set Level to 0 and click Write.
4. Click Close to end the lights testing.
Switching S60 keyboard lighting ON using Phoenix
Prerequisites
First, go through steps 1-5 in
Page 3 –50
Switching display lighting ON using Phoenix (page
Switching display lighting ON using Phoenix (page
COMPANY CONFIDENTIAL
Copyright © 2007 Nokia. All rights reserved.
BB Troubleshooting and Tuning Guide
3–49), if not done yet
3–49), if not done yet.
RM-313
Issue 1