If An Error Code Is Displayed - Olympus CAMEDIA C-500 ZOOM Advanced Manual

Direct printing (PictBridge)

If an error code is displayed

If an error code is displayed on the camera's monitor during direct print setting or
printing, see the following table.
For more details, refer to the printer's instruction manual.
Monitor indication
NO CONNECTION
NO PAPER
NO INK
JAMMED
SETTINGS CHANGED
7
PRINT ERROR
TIPS
• If an error code other than those shown above is displayed, see "Error codes"
(P. 122).
98
Possible cause
The camera is not
connected to the printer
correctly.
There is no paper in the
printer.
The printer has run out of
ink.
The paper is jammed.
The printer's paper
cassette has been removed
or the printer configuration
has been changed.
There is a problem with the
printer and/or camera.
Corrective action
Disconnect the camera and
connect it again correctly.
Load some paper in the
printer.
Replace the ink cartridge in
the printer.
Remove the jammed paper.
Do not reconfigure the
printer after the settings have
been made.
Turn off the camera and
printer. Check the printer and
remedy any problems before
turning the power on again.