Cobra MARINE HH500 Owner's Manual page 21

Advanced Operation
VHF Marine Radio Protocols Operating Your Radio
Memory Location Mode
ENT SETUP
MEM/ESC Button
Your radio has unlimited memory locations for storing your
most frequently used channels. These memory locations can
MEM
be selected individually or can be scanned. (See page 37
ESC
under Memory Location Scan.)
To enter Memory mode, press MEM/ESC button. The display
will show the MEM icon and the Memory Channel bank will
be displayed on the matrix.
Memory Location Number
To Program Memory Locations:
GMRS
VHF
1. Press and hold the MEM/ESC button for two (2)
R
X
T
seconds. The memory location number will be
A
displayed on the matrix and the MEM icon will be
B
U C I
turned On.
ATIS VOX LOMEDHI SAME MEM
2. Use the Channel Up/Down button to advance to the
memory location (00-99) you want to program.
MARINE HH50
Channel Up/Down Buttons
3. Press the MEM/ESC button to select the memory
location.
4. Use the Channel Up/Down button to change to the
channel you want to store into the selected memory
location.
CALL
5. Press the MEM/ESC button to program that channel.
ENT SETUP
The memory location will be displayed on the matrix
again.
Channel Number
Repeat steps 2 through 5 to program as many
GMRS
VHF
additional memories as you want.
R
X
T
6. Press and hold the MEM/ESC button for two (2)
A
seconds. This will return the radio to Memory mode.
B
U C I
7. Press and release the MEM/ESC button again to
ATIS VOX LOMEDHI SAME MEM
return to Marine Standby mode.
34 English
Advanced Operation
Operating Your Radio VHF Marine Radio Protocols
To Recall a Stored Memory Location:
MEM Icon
GMRS
1. Press the MEM/ESC button. The MEM icon will be
VHF
R
turned On.
X
T
2. Press the Channel Up/Down button to select the
A
memory location. If a memory location has been
B
U C I
ATIS VOX LOMEDHI SAME MEM
programmed, its associated channel will display on
the LCD. Your radio is now in Marine Standby mode
on the selected memory location.
To Exit Memory Location Mode:
Press the MEM/ESC button to return the radio to
Marine Standby mode. The last channel used in
Marine Standby mode will now be displayed on the
LCD and the MEM icon will disappear.
To Erase Stored Memory Locations:
1. Press and hold the MEM/ESC button for two (2)
seconds. The memory location number will be
displayed on the matrix and the MEM icon will be
turned On.
2. Use the Channel Up/Down button to advance to the
memory location you want to erase.
3. Press the MEM/ESC button to select the memory
location.
4. Use the Channel Up/Down button to change to the
channel to read "00" at the selected memory
location.
5. Press the MEM/ESC button to erase that channel.
Repeat steps 2 through 5 to erase as many additional
memories as you want.
6. Press and hold the MEM/ESC button for two (2)
seconds. This will return the radio to Memory mode.
7. Press and release the MEM/ESC button again to
return to Marine Standby mode.
Nothing Comes Close to a Cobra ® 35