Olympus Stylus 800 Advanced Manual page 131

Possible cause
The monitor is hard to see.
There is condensation
inside the camera.
The brightness of the
monitor is not adjusted
properly.
The monitor is exposed
to direct sunlight.
Vertical lines appear on
the monitor screen
during shooting.
The date recorded with the image data is wrong.
The date and time is not
set.
The camera has been
left without the battery.
The settings are returned to the factory default settings when the camera is turned
off.
[ALL RESET] is set to
[ON].
The picture is out of focus.
The subject was too
close.
Auto focus is not
possible.
There is condensation
inside the camera.
The monitor goes off.
The camera is in the
sleep mode.
Corrective action
*
Turn the camera off. Before turning it on
again, wait until the camera adjusts to the
surrounding temperature and dries out.
Use [s] to adjust the brightness.
Block the sunlight with your hand.
Aiming the camera at a bright subject in
sunlight may cause vertical lines to appear
on the screen. This is not a malfunction.
Set the date and time. The clock is not preset.
If the camera is left for 1 day without a
battery, the date and time setting is canceled.
Set the date and time again.
Set [ALL RESET] to [OFF].
Move further away from the subject. To take
pictures at 20 to 50 cm (7.9 in. to 19.7 in.)
from your subject, use macro mode. To take
pictures closer than 20 cm (7.9 in.), use super
macro mode.
Use the focus lock to focus on the subject.
*
Turn the camera off. Before turning it on
again, wait until the camera adjusts to the
surrounding temperature and dries out.
Press the shutter button or zoom button.
Troubleshooting
Ref.
page
–
P. 91
–
–
P. 92
P. 92
P. 85
P. 40
P. 22
–
–
131
9