Continuous Firing - Olympus FL 50R Instruction Manual

Continuous firing

Continuous firings make the light-emitting section hot and may result in
its deterioration, malfunction or deformation. Therefore, continuous firing
should be limited to the counts shown in the following table. Always leave
the electronic flash unused for at least 10 minutes after continuous firing
up to the limit count.
Limit counts of continuous firings
Flash intensity
FULL; 1/1
1/2
1/4
1/8 - 1/128
Available counts of flash emission synchronized with continuous
shooting (at 8 frames/sec.)
The following table shows the flash emission count that can be
synchronized to the continuous shooting of the camera. Note, however,
that the electronic flash should be left unused for more than 10 minutes
once the maximum continuous flash emission count has been reached.
External power
supply
Without external
power supply
Flash Power Grip
FP-1
(C (R14) alkaline
batteries/C (R14)
NiCd batteries)
High Voltage Pack
HV-1
(NiMH battery pack
BN-1)
48
EN
For your safety,
be sure to observe the following.
Flash interval
1 sec.
0.5 sec.
0.3 sec.
0.2 sec. or less
FL-50R
Internal
1/4
battery
2
With
frames
2
With
frames
2
Without
frames
4
With
frames
4
Without
frames
Limit count
10
20
40
80
Flash intensity
1/8 1/16 1/32
5 10 16
frames frames frames
5 16 40
frames frames frames
5 12 18
frames frames frames
40 40 40
frames frames frames
20 40 40
frames frames frames
1/64 1/128
30 40
frames frames
40 40
frames frames
40 40
frames frames
40 40
frames frames
40 40
frames frames