Troubleshooting; Indoor Display Error And Check Method - Samsung NS100SSXEA Service Manual

4. Troubleshooting

4-1 Indoor Display Error and Check Method

Error detection and reoperation
■
▶ If error occurs during the operation, badness is indicated by LED flickering and all operation is stopped except LED.
▶ When reoperating by remote control and switch determine the error mode after normal operation.
Indoor unit LED lamp display at error detecting
■
Power reset
Error of temperature sensor in the indoor unit(Open/Short)
Error of heat exchanger sensor in the indoor unit
Error of the outdoor temperature sensorError of the condensor
temperature sensor
Error of the discharge temperature sensorPower reset
1. No communication for 2 minutes between indoor units
(Communication error for more than 2 minutes)
2. Indoor unit receiving the communication error from
outdoor unit
3. Outdoor unit tracking 3 minutes error
4. When sending the communication error from the outdoor
unit, the mismatching of the communication numbers
and installed numbers after completion of tracking4.
(Communication error for more than 2 minutes)
1. Error of electronic expansion valve close
2. Error of electronic expansion valve open
3. 2'nd detection of high temperature cond
4. 2'nd detection of high temperature discharge
5. Error of reverse phase
6. Compressor down due to 6'th detection of freezing
Detection of the float switch
Error of setting option switches for optional accessories
EEPROM option error
● : ON, ◑ : Flickering, X : OFF
※ If you turn off the air conditioner when the LED is flickering, the LED is also turned off.
4-1
NS090SDXEA_E_SM_33623A(1)_1.indd 1
Error type
LED Iamp display
Operation Defrost Timer
◑ X X
X X ◑
◑ X ◑
◑ X X
X X ◑
X X ◑
X X X
X X ◑
◑ ◑ ◑
Air flow Filter
Remarks
X X
X X
X X
◑ X
◑ X
◑ ◑
◑ ◑
X ◑
◑ ◑
Samsung Electronics
2011-04-08 10:54:54