Electronic Ignition System - Jenn-Air JDRP548W Installation Instructions Manual

Electronic Ignition System

Install Burner Bases and Burner Caps
Install the burner base, making sure the igniter electrode
is properly aligned with the base. Place burner caps on top
of burner bases. If burner caps are not properly positioned,
surface burners will not light.
Ultra Power™ Dual-Flame Burner
Professional Burner
Simmer/Melt Burner
Initial Lighting and Gas Flame Adjustments
Cooktop burners use electronic igniters in place of standing
pilots. When the cooktop control knob is turned to any position,
the system creates a spark to light the burner. This sparking
continues until the flame is lit or the knob is turned to OFF.
NOTE: The first time igniting the burners will take longer.
This allows the gas to reach the burners during the first use.
Check Operation of Cooktop Burners
Push in and turn each control knob to LITE.
NOTE: You will hear a clicking sound while the line clears.
The surface burners and grill flames should light within
4 seconds. The first time a burner is lit, it may take longer
than 4 seconds to light because of air in the gas line.
After verifying the proper burner operation, turn the control
knobs to OFF.
If burners do not light properly:
Turn cooktop control knob to OFF.
■
Check that the range is plugged in and the circuit breaker
■
has not tripped or the fuse has not blown.
Check that the gas shut-off valves are set to the
■
"open" position.
Check that burner caps are properly positioned on
■
burner bases.
Repeat startup. If a burner does not light at this point, contact
your dealer or authorized service company for assistance.
16
A
A. Incorrect
B. Correct
B
A
A. Incorrect
B. Correct
B
A
A. Incorrect
B. Correct
B
Flame Height
The cooktop flame should be a steady blue flame
approximately ¼" (0.64 cm) high.
Dual Flame Burner
A
B
A. Upper (simmer) flame
B. Lower flame
Single Flame Burner
To Adjust Flame Height:
1. Unplug range or disconnect power.
2. Remove burner grates.
3. Remove the control knobs.
4. Open the oven door and remove the 2 screws on each
side of the range that hold the control console in place.
NOTE: Make sure to leave oven door open or the control
console will not rest in the side brackets properly once it
is detached.
5. Pull up on the control console, and let it drop forward into
the notched console brackets on each side.
A
A. Control console bracket
6. Remove the round gasket from the valve stem.