Programming The Pbx - Panasonic KX-TDA100 Getting Started

4.3 Programming the PBX

Starting the Maintenance Console and Assigning the Basic Items (Quick
Setup)
When you start the Maintenance Console with the Installer Level Programmer Code and connect to the PBX
for the first time after initialisation (with the factory default setting), Quick Setup will launch automatically. During
Quick Setup, you will set up the basic items. For details about the basic items, refer to "2.3.4 Quick Setup" in
the Feature Guide.
1. Connect the PC to the PBX with a USB cable or RS-232C
cross cable.
2. Start the Maintenance Console from the Start menu.
3. "Information before programming" appears.
a.
Carefully read this important additional information,
which includes updates to this and other manuals.
b.
Click OK to close this window.
4. a.
Enter the Installer Level Programmer Code (default:
INSTALLER).
b.
Click OK.
5. Click Connect.
6. a.
Select KX-TDA100/200 from PBX Model.
b.
Select the USB or RS-232C tab, depending on the
serial interface connection with the PBX.
c.
Enter the system password for installer (default: 1234).
d.
Click Connect.
7. When country/area data do not match:
a.
Click OK to replace the country/area data of the PBX.
Replacement may take several minutes to complete.
b.
Follow the procedure described in "Section 3 Starting
the PBX" and restart the PBX.
c.
Repeat step 5 to reconnect the Maintenance Console.
4.3 Programming the PBX
Getting Started 23