3Com AP9552 Hardware Installation Manual page 13

Indicator
LED 1
(Power/
System)
LED 2
(2.4G)
LED 3
(5G)
LED 4
(Ethernet)
3 Connecting to the AP(FAT AP)
On a Network with a DHCP Server
The DHCP server automatically assigns an IP address to the AP.
To find the address, either get it from the DHCP Server, or enter the following command
at the CLI interface:
<9552> display vlan 1
On a Network Without Any DHCP Server
The AP uses the default factory configuration that includes the following information.
The default IP address of the AP is 192.168.0.50.
The AP has the Telnet server enabled by default. The default authentication
username and password are admin, and password respectively (case
sensitive). You can remotely manage and maintain the AP through Telnet.
Log into the AP (FAT AP)
To Log into the AP after you determine its IP address, follows these steps:
Color State
Off
On
Amber
Blinking
Green On
Off
Green On
Blinking
Off
Green On
Blinking
Off
Amber
On
Blinking
On
Green
Blinking
Description
No power
Failure of CPU or system
System initiation or reset (software self-
testing and loading)
Powered on and ready for operation
Radio disabled
Radio enabled
Activity
Radio disabled
Radio enabled
Activity
No 10/100/1000 BASE-T link detected, or
administratively disabled
10/100 BASE-T link detected; no activity
10/100 BASE-T link activity
1000 BASE-T link detected; no activity
1000 BASE-T link activity
10