Top Vent Adapter Installation; Rear Vent & Rear Vent To Top Vent Adapter Installation - Quadra-Fire SANTAFE-MBK Installation Manual

C. Top Vent Adapter Installation
3 to 3 inch Top Vent Adapter
3 to 6 inch Top Vent Offset Adapter
Installing the Top Vent Adapter
1. Put a layer of high temperature silicone on the 3 inch
(76mm) exhaust outlet. Do not put silicone inside of
pipe. Figure 19.1
2. Slide the top vent adapter onto the rear exhaust outlet
and adjust the assembly to a vertical position. Figure
19.1.
3. Drill 4 holes with #26 drill bit (provided) into the back of
the appliance using the outer shield as a pattern (make
sure the assembly is vertical). Figure 19.2.
4. Install the 4 mounting screws.
5. Drill 2 holes with #26 drill bit through the rear exhaust
outlet using the 2 holes already in the short horizontal
pipe in the top vent adapter as a guide. Install the 2
screws. Figure 19.1.
6. Install the vent pipe into the top vent adapter (be sure to
silicone all joints).
7. To clean the top vent adapter open the clean-out cover.
Figure 19.2.
3 to 6 inch
Offset Adapter
3 to 3 inch Top
Vent Adapter
Use Hole on Each
Side as Drilling Guide
Figure 19.1
August 3, 2015
Silicone Rear
Exhaust Outlet
Figure 19.2
D. Rear Vent & Rear Vent to Top Vent Adapter
Installation
1. Put a layer of high temperature silicone on the 3 inch
(76mm) exhaust outlet. Do not put silicone inside of
pipe. Figure 19.1.
2. Slide the adapter onto the rear exhaust outlet and adjust
the assembly to the appropriate position.
3. Install the vent pipe into the adapter (be sure to silicone
all joints).
Clean-Out Cover
Figure 19.3 - Rear Vent Adapter
Clean-Out Cover
Figure 19.4 - Rear to Top Vent Adapter - 90
7050-145E
SANTA FE FREESTANDING
Drill Holes in back of
stove and secure with 4
screws, 2 on each side
Clean-Out Cover
o
19