Operational Check For The Remote Control; Table 3-3 Operational Check - Motorola DCT6200 Installation Manual

3-14 Installation
Code Description
Eb 11 Failed to lock OOB
frequency
No COAC message
Eb 12
received
No DLC message
Eb 13
received
Bad object type or class
Eb 14
No matching Platform
Eb15
ID found
Object size mismatch
Eb18
Object size failed range
Eb19
check
Invalid SUDB pointer
Eb20

Operational Check for the Remote Control

The operational check tests the communication link between the remote control and the DCT*.
Table 3-3 lists the operational check procedures:
Table 3-3
Operational check
Feature Testing Procedure
Power on Press
Tune to the output channel of the DCT* (channel 3 or 4).
Channel selection Scan through the channels using the
Tune to several channels by entering the channel number using the numeric keys.
Volume control Press
lowest level, and to a comfortable level.
Press
If the DCT* does not operate properly, refer to Section 5, "Troubleshooting".
DCT6200\DCT6208 Installation Manual
When Error Occurs
After cycling twice through the OOB
frequencies (LED then displays Eb 02
indicating the software object download
was unsuccessful)
After cycling twice through the OOB
frequencies (LED then displays Eb 02
indicating the software object download
was unsuccessful)
After cycling twice through the OOB
frequencies (LED then displays Eb 02
indicating the software object download
was unsuccessful)
After the LED displays dl, indicating
failed during attempted download
After cycling twice through the OOB
frequencies (LED then displays Eb 02
indicating the software object download
was unsuccessful)
After the LED displays dl, indicating
failed during attempted download
After the LED displays dl, indicating
failed during attempted download
After plugging the DCT* into an electrical
outlet to begin the boot cycle
to turn on the DCT*.
POWER
+ or - on the remote control to increase the volume to its upper limit,
VOLUME
to turn the sound off. Press
MUTE
Action Required
Ensure proper cable
connections
Contact headend
operator
Contact headend
operator
Contact headend
operator
Contact headend
operator
Contact headend
operator
Contact headend
operator
None
+ or - keys.
CHANNEL
again to restore the sound.
MUTE