Canon imageRUNNER ADVANCE 500i Trouble Error Codes List page 18

No necessary memory at Main
1024
Controller PCB
Image memory is faulty or insufficient
E613-
No necessary memory at Main
1536
Controller PCB
E614 Flash PCB detection error
FAX Board communication error
The specified number of errors was
E674-
0001 detected with FAX Board
communication
FAX Board communication error
E674-
Error in access of the modem IC used
0004
by FAX
FAX Board communication error
E674-
Error in access of the port IC used by
0008
OnBoardFax
FAX Board communication error
E674-
An error was detected in access of the
000C
modem IC or port IC used by Fax
FAX Board communication error
E674-
Error in timer device to be used by
0010
FAX at activation
FAX Board communication error
E674-
Error when the timer device to be
0011
used by FAX is started
FAX Board communication error
E674-
Checksum error of USB-FAX
0030
MAINROM
E674- FAX Board communication error
18
Controller PCB (PCB2).
Make a 1536MB memory at Main
Controller PCB (PCB2).
1. Check wire connection between the
FAX Board and the Main Controller
PCB.
2. Replace the FAX Board.
3. Replace the Main Controller PCB
(PCB2).
1. Check wire connection between the
FAX Board and the Main Controller
PCB.
2. Replace the FAX Board.
3. Replace the Main Controller PCB
(PCB2).
1. Check wire connection between the
FAX Board and the Main Controller
PCB.
2. Replace the FAX Board.
3. Replace the Main Controller PCB
(PCB2).
1. Check wire connection between the
FAX Board and the Main Controller
PCB.
2. Replace the FAX Board.
3. Replace the Main Controller PCB
(PCB2).
1. Replace the Main Controller PCB
(PCB2).
1. Replace the Main Controller PCB
(PCB2).
When the power is turned ON, get in the
download mode from service mode to
execute downloading of USBFAX
MAINROM.
Turn OFF and then ON the power.