Canon imageRUNNER 2420 Trouble Error Codes List page 26

power on, although it was connected
before the power was turned off because
of an error.
There is an error in the communication
with the NE controller.
An IPC error has occurred while the NE
E717-
controller is in operation. There is an
0002
open circuit for the IPC. An error has
occurred, and the IPC communication
remains disabled
There is a coin vendor error.
The coin vendor is not connected when
E719-
the power is turned on, although it was
0001
connected before the power was turned
off because of an error.
There is a coin vendor error.
While the coin vendor is in operation, an
IPC error has occurred, IPC has
developed an open circuit, or an error
E719-
preventing recovery of IPC
0002
communication has occurred. An open
circuit has been detected in the line for
the pickup/delivery signal. An illegal
signal has been detected.
There is a coin vendor error.
E719- While the unit price is being checked at
0003 startup, an error occurs in the
communication with the coin vendor.
There is a coin vendor error.
An error has occurred at new card reader
E719- startup. The new card reader is not
0011 connected when the power is turned off,
although it was connected when the
power was turned off.
There is a coin vendor error.
An IPC error has occurred at new card
E719-
reader startup. There is an IPC open
0012
circuit. An error has occurred that
prevents recovery of IPC communication.
There is a PDL software error
E730-
1001 An initialization error has occurred.
There is a PDL software error
E730- An error that may be critical to the
100A system (e.g., failed initialization) has
occurred.
E730- There is a PDL software error
26
Check the cable; thereafter, reset the
condition in service mode:
COPIER>FUNCTION>CLEAR> ERR.
Check the cable; thereafter, reset the
condition in service mode:
COPIER>FUNCTION>CLEAR> ERR.
Check the cable; thereafter, reset the
condition in service mode:
COPIER>FUNCTION>CLEAR> ERR.
Check the cable; thereafter, reset the
condition in service mode:
COPIER>FUNCTION>CLEAR> ERR.
Check the cable; thereafter, reset the
condition in service mode:
COPIER>FUNCTION>CLEAR> ERR.
Check the cable; thereafter, reset the
condition in service mode:
COPIER>FUNCTION>CLEAR> ERR.
1. Execute PDL resetting. 2. Turn on the
power once again.
1. Execute PDL resetting. 2. Turn on the
power once again.
1. Turn on the power once main. 2. Check the